mar

Hi,

I am wondering if it is possible to select several cross-sections in module xns, using keys combination? E.g. I have 1000 cross-sections and I have to choose 44. Should I choose one by one or there is any trick? :)

Regards,
Mar

Hi everyone,
Could somebody explain me how properly specify the link channels? I know the idea of them, but I have some problem with visualisation and specifying their parameters. So then, the bed level US is the point of a high bank, the bed level DS is one of the first point of a floodplain. What geometry I specify in cross section geometry?

Thanks in advance.
Mar

Hi,
Could you help me with Control Structures? How should I define a control point which would check does its value occur second time?
For example, I would like to know whether the value of discharge at a point has appeared before,e.g. 72 hours before current state.

Thank you for every tips.
mar

Hi,

Could you tell me what's the difference between Volume [b]H or Q point[/b] and [b]Total[/b]? Because when I'm ticking both items and then I'm checking the value (sum of volume in points and total volume), they're differing. I'd like to know of the reasons impact the result and the difference between each other.

I'll be deeply grateful for explanations.

Kind regards,
Mar

Hi,

I have a question about projects. It is possibile to open an existing project and there is a list of those projects in MIKE11. It appears in two places: Recent Projects and Open an Existing Projects.

My question is: how can I move it on? I have a list with some projects, but now I would like to clear it without deleting files or .mzp. Is it possible? In what way I can do that?

Regards,
mar

I'm very thankful for your example. It's working and I found out what I did wrong.

Kind regards,
mar

Hi,
I have the same problem, after pfsmerge.exe starting it appears a message:
"Loading xx.nwk11 ...
Error when opening xx.nwk11
Program Halt 1
"
I do not know what I am doing wrong. Could you tell me more about using pfsmerge.exe, please? What is right command? What could be the reason of this message?

I will be greatful for any advices.
mar