Juliette

Hello all,

This module sounds interesting for me as well (soon, I'll have to simulate water release from a dam / river flood and it's impact on groundwater). Does the module include the time schift of time series along the river meshes ?

Another (related) question : I would like to simulate the propagation of a pollutant in a river and it's impact on groundwater. I am planning on setting the river meshes with concentration imposed bc (1st kind). But I'll need to set different time series (for concentrations) in every meshes. Is there a short way to do so ?

Thanks in advance for your answer,

Juliette

Hello,
I have 2 questions:

- The tolerance acts on both head & concentration (for a unsat flow + transport), right? If so, is there a way to go around that ? I would like to set a strongh tolerance on flow and a weak one on the transport...

- I can't display the 'error norm history' & the 'residual history' windows from the quick access menu. I suppose those are available under specific conditions. What shall I do to get these windows?

Thanks in advance !

Juliette

ok thanks.
Would be great if it exists in the next version!

Hey,

Does anybody know if it exists a mass flux analyzer such as the fluid flux analyzer?
I would like to check the mass balance in some cells of the model, i.e. quantify the mass that comes horizontally and vertically.
Is that possible?

Thanks,

Juliette

thanks for this quick answer!

Hello,

I am running Feflow in batch mode. I would like to check how the simulation goes (seeing the time steps while running). Does anybody know if  it's possible?

thanks,
Juliette

Hello,
I would like to view the time variations of both saturation & concentration (my model is a 3D unsaturated flow + transport one). On Feflow explorer, I manage to open 2 presentation windows (one for saturation, the other for concentration) but I can only run one of the window at a time. Do you know if it's possible to synchronize the two presentation windows?
thanks,
Juliette

just a simple question:
does anybody know if it's possible to view an other parameter (let say the saturation) than the hydraulic head while a model is running?

Juliette

thanks for the advices!

Hey,

How about exporting XZF data from a 3D multilayers model (ideally one could choose the horizontal data along a segment)? Do you know if it's possible?

Juliette