web
You’re offline. This is a read only version of the page.
close
Please wait...
×

Error



Posted 12 years ago by Hagi
Hi all

For my master thesis I am investigating the potential using the retention capacity of a sewer system. To regulate the system I tried to use gates. However so far none of my attempts to implement a control mechanism were succesful :-(
At first I am trying to control a gate with a PID-controller to get a constant discharge of 210 l/s. (I know this would be possible using local controls in the link. However I will need more functions later on and therefore have to do it using the control module.)
I tried to get all the important information of my setup on a screenshot. Q MS is a discharge sensor located in the link following the gate.

[quote]Fehler 551 : Eine oder mehrere Kontrollfunktionen in Anwendung 'KS 103' passen nicht zu den gewählten Anwendungs- und Kontrolltypen.
[/quote]

So far I have tried many different methods, however none have worked. :-( Could anybody give me some tips on what I am doing wrong?
Also I would be thankful for any documentation about the controlling module. The chaptre about it in the manual is rather brief and not of much help when configuring a PID. Thanks for any advice in advance!  Hagi
Posted 12 years ago by Marcus Richter
Hi Hagi,

you will be soon contacted by our support team to guide you through the model set-up.

best regards...

>Marcus<

You must be signed in to post in this forum.