Please wait...
×

Error

Posted Thu, 22 Aug 2013 00:57:30 GMT by Ki-hoon Kim
I use FEFLOW 6.1 with BHE.
I set up the BHE model. and run with standalone. and then appear following message.

"Reference distribution BHE-dT and BHE-dp not defined - BHE module deactivated!"

but it's running.
Do i ignore that warning? or What should i do?

Thank you.
Posted Fri, 30 Aug 2013 11:41:55 GMT by Julia Mayer
This message shows if the nodal distributions that the plug-in BHELoop expects are not defined. If you work with FEFLOW 6.1, this plug-in is actually not necessary as FEFLOW itself provides the plug-in's functionality. In older FEFLOW versions this plug-in was required if you wanted to prescribe a temperature difference between BHE inlet and outlet but in the current version you simply use the BHE boundary condition and the options "Temperature difference" and "Power difference".
Posted Wed, 04 Sep 2013 03:09:36 GMT by Ki-hoon Kim
It is my mistake. I use FEFLOW 6.0.
your reply is very useful.

but we defined nodal distributions and so on.
and we received same warning message.
when we ignore message and going on.
then we have got results as expected.

Also when we excluded BHE loop in the BHE modules(BHE Integrator and BHE Loop),
we did not receive above warning message.

[size=12pt][i][b]do we should ignore that warning message? or excluding BHE loop, is it OK?[/b][/i][/size]

When can we use BHE loop?

Thank you very much.

You must be signed in to post in this forum.