-
Can i get ifm dll to import data from fracman to feflow 7.0? If it exists...
I wish to import data from fracman's some data files into feflow 7.0.
Can i get ifm dll to import data from fracman to feflow? :) -
Where can i find "original value" on following warning message?
We use FEFLOW 6.0 FH3 with BHE modules and TRNSYS (http://en.wikipedia.org/wiki/TRNSYS).
When we run FEFLOW, we've got following warning message.
"Warning: Setting final time according with TRNSYS to 213.958 difference to original value is 235.433"
Warning Image (http://setup.partswox.com/Warning.png)
We are setting on FEFLOW like as following images.
TRNSYS Settings Image (http://setup.partswox.com/TRNSYS.png)
Problem Settings Image (http://setup.partswox.com/ProblemSettings.png)
we did not enter original value (235.433).
Where can i find "original value"?
Thank you. -
Re: what should i do? warning is "Reference distribution BHE-dT and BHE-dp not defi
It is my mistake. I use FEFLOW 6.0.
your reply is very useful.
but we defined nodal distributions and so on.
and we received same warning message.
when we ignore message and going on.
then we have got results as expected.
Also when we excluded BHE loop in the BHE modules(BHE Integrator and BHE Loop),
we did not receive above warning message.
[size=12pt][i][b]do we should ignore that warning message? or excluding BHE loop, is it OK?[/b][/i][/size]
When can we use BHE loop?
Thank you very much.
-
what should i do? warning is "Reference distribution BHE-dT and BHE-dp not defi
I use FEFLOW 6.1 with BHE.
I set up the BHE model. and run with standalone. and then appear following message.
"Reference distribution BHE-dT and BHE-dp not defined - BHE module deactivated!"
but it's running.
Do i ignore that warning? or What should i do?
Thank you.