Tijana Micic Vodnogospodarski biro Maribor d.o.o.

Now it works.

Thank you for your quick reply.

Tija

I've tried your suggestion. In »Data Manager« I couldn't find delete option under “Items”. Instead I open the file in “MZ Grid Series”, where I could delete this extra item, but M21 Discharge calculation tool still doesn’t recognize the file as right format, even though it now contains only H,P, Q.

Tija

Hi.

I have a full 2D model and I would like to calculate discharge trough a cross section. The problem is, that the data file type must be (H,P,Q). My MIKE21 HD output file also contained surface elevation and now it doesn’t work for discharge calculation.

Is it somehow possible to calculate discharge in a cross section with this existing result file or I have to repeat the simulation?

Thank you for your answer.
Tija

Hi.

When I've tried to use MZ Toolbox Statistics on matrix series to export maximum values from *.dfs2 file I got “Error running engine!!” message.
I‘m using version 2014.  I’ve tried the same thing on old version of Mike (2009) and it worked fine. Do you have any suggestions how to solve this problem?

Thank you. Best regards.

Tija

It works. Thank you.

Tija

Hi.
Is it possible to read partial MIKE11 results (in MIkeview) if MIKEFLOOD calculation terminates at one point because of some instability? This was possible in previous versions, but in 2014 version no results are shown in Mikeview.  This only happens if calculation terminates in MIKEFLOOD, if calculation terminates in MIKE11, partial results can be seen in Mikeview.

Best regards.
Tija