samsamia22

Hi,
Thank you peter for the quick response.
The isoline is horizontal even if I change the pumping rate and increase it significantly. I also checked the hydraulic heads at each node along different locations and it was lower than the isoline.
Is there another way to calculate the water table elevation?
Thank you

Hello,
I am modeling a pumping test and I want to visualize the drawdown of the water table. I want to see the elevation of the ground water at different locations. Does anyone know how to do so ?
I tried to plot the zero isoline (cross section view) but it gave me a horizontal line although the calculated hydraulic heads are lower than the zero isoline.
I was considering to create a function that calculates the average hydraulic head at each location ( average hydraulic head at each node for the same location but at different elevations) and then plot the average hydralic head and consider it as the water table elevation, but I didnt know how to.
Does someone has a better solution or can show me how to create that function ?
Thank you
Sam