Tom Lecomte

Hello,

I am trying to set some control rules on a pump station but it doesn't seem to work very well so far... :(

My PS is controlled both by its own water level (starts ABOVE 13.4m and stops BELOW 12.9m) and by the water level of the downstream PS (starts when ds PS level BELOW 12.8m and stops when ds PS ABOVE 13.4m).
I have created:
- 1 sensor in the ds PS to check the level
- 2 conditions (sensor <12.8m and sensor >13.4
- 1 action (I assume I should use the Setting Start/Stop levels as action type but I am confused as I have to enter newly some start and stop level + an input value (?) while I was expecting to enter an action which would just switch the pump On and Off...
- The RTC in controllable device which gathers my condition and my action (in this table I am not too sure about what should be the min stop level and min start level)

The model ran but I am not satisfied with the results as my pump doesn't seem to obey the rules.
Does anybody know how to set it up properly ? I am especially intrigued by the "action" table, isn't there a way to simply activate/deactivate my pump when it respects the conditions.

Thank you for your help,

TomL