Michael Verreault, ing., M.Sc.A. hydrogeologue - Président

Michael Verreault, ing., M.Sc.A.

Joined: 1/20/2019

  • Unstructured mesh design

    Wed, 02 Dec 2015 21:06:46 GMT – Unstructured mesh design
    Just get Feflow 7. I am trying to mesh a 3D geometry (mesh) initially built on Surpac (similar to leapfrog). The transfert format is DXF or 3DS. I can open both in Feflow, but can't generate the mesh.

    Then I tried a very simple mesh, a kind of a sphere that I built in 1 minute in 3DS MAX, then exported the mesh in 3DS format, then opened it in Feflow 7, using the fully unstructured mesh option. The sphere appears, but here again, no way to mesh it.

    I guess I am doing something wrong as the mesh files are quite simple, if I compare it to some DHI presentation of Feflow 7.

    Any help would be welcome, as I have a lot of expectation from this version of feflow.

    Tks, Michael