Hello, I am trying to create a MIKE 3 Flow Model to calculate current speeds in
a river. Before I have done that with MIKE 21 but I want to compare the results
with a 3D model to figure out the differences below surface level. After
importing the mesh into the Flow Model, configuring a few parameters and
defining one point output I get the following error:
Fatal error: BLOW-UP - Total depth too small
time : 0
element number : 117
domain : 12
x-coordinate (center) : 506146.528
y-coordinate (center) : 5971145.23
total water depth (h) : 0
surface elevation (s) : 0
still water depth (d) : 0
I realize that "total water depth" with the value of zero does not look correct.
I set the output point in the middle of the river and expect about 8m of water
depth. The bathymetry data I am using worked fine for MIKE 21. For any advice or
hint I will be very thankful! Best regards, Finn Christiansen
