Simulation outputs only t=0

Hello again,

I'm having an issue where I run my simulation and it finishes in about 2 or 3 seconds and only outputs the initial conditions given for t=0 (i.e., initial water surface elevation, and velocity field = 0 since it's a cold start).

The simulation period is supposed to be 2.5 hrs with a time step of 15 seconds. The courant number is reasonable and I've made sure everything is defined properly: my boundaries and boundary conditions are defined and they are initially submerged given the starting water level.

There is no errors when I run it so I am not sure why this is happening. Any thoughts?

Hi Steven,

probably it would be good, if you could post the setup - file to me.
It seems, that something with your simulation time is wrong.

As shown in your picture, the simulation should at least last 72 timesteps * 15 secs = 1080 secs = 18 minutes.

Have you checked the error log, if some error was reported ?

Bests Christian