You’re offline. This is a read only version of the page.
Search all support and community content
Mon, 09 Sep 2013 18:07:35 GMT
Civil Engineer / Hydrologist
I had to make an assumption that flow entering a node from a single link splits 50-50 to two links exiting the node. Is there a way to do this in MIKE URBAN?
Mon, 16 Sep 2013 14:55:09 GMT
As a quick answer, I would assume that you could replace the two outgoing links by two pump functions. If you use a Q-H curve, the pump capacity is only dependent on the water level in the node, which is the same for both pumps.
Of course you have to think about a reasonable pump capacity curve, but as the whole approach sounds rather conceptual, this shouldn't be a big problem.
You must be signed in to post in this forum.