Please wait...
×

Error

Posted Thu, 12 Nov 2020 17:06:48 GMT by Samia Shaaban
Hi all,
I want to use [b]IFMSETtParamValues[/b] to define [b]In/outflow on top/bottom layer constant[/b] but not one constant value for the whole simulation, to be different transient values.

Any ideas please?.
Looking forward to hearing for you. I'm beginner in using IFM programming interface.

Samia

Posted Mon, 16 Nov 2020 06:39:24 GMT by Peter Schätzl Grundwassermodellierer
Transient material data such as recharge cannot be set via the programming interface.
Posted Tue, 17 Nov 2020 20:02:20 GMT by Samia Shaaban
Thanks Peter
Posted Fri, 11 Dec 2020 08:29:44 GMT by Carlos Andres Rivera Villarreyes Global Product Specialist - FEFLOW
Hi Samia,

Allowing the creation of the material time-stages through the IFM interface is one of the prioritizes for the future release. There are some workaround, but they require few more extra code lines.

Cheers
Carlos

You must be signed in to post in this forum.