web
You’re offline. This is a read only version of the page.
close
Please wait...
×

Error



Posted 9 years ago by Muthu
i am using feflow 6.0. i have assigned the necessary parameters for steady state. But if i run it in steady state condition the hydraulic head values changes to the boundary condition values. Though i change the conductivity values i couldn't see any variations in the output. Kindly suggest me an idea to overcome this issue.

thank you
Posted 9 years ago by Björn Kaiser
Did you assign Dirichlet BC's at these nodes? If you assign Dirichlet BC's you fix the hydraulic head. Accordingly, the hydraulic head values for the process variable are the same as the hydraulic head values you used for the BC.

You must be signed in to post in this forum.