web
You’re offline. This is a read only version of the page.
close
Please wait...
×

Error



Posted 12 years ago by zhengq
For 2D axisymmetric model in FEFLOW, does it have to represent a cross section of a cylinder? Can it represent a cross section of a truncated cone (using a plane parallel to the lateral surface)?

Thanks,

Quinn
Posted 12 years ago by Denim Umeshkumar Anajwala
I'm not sure if I got this right, but if the right-hand side of the outer boundary is inclined instead of vertical then you'd have a section of a truncated cone. No problem with this.

You must be signed in to post in this forum.