Posted Fri, 28 Dec 2007 11:58:43 GMT by George Kopsiaftis
Hello everybody!

I'm a new Feflow user with little experience in programming.  :(
I would like to create some simple flow - mass transport problems and use them along with an optimization module. Is there a way to do that? For example: is there a way to run Feflow iteratively, changing for example well-pumping each time?
Any help would be appreciated.

Posted Thu, 03 Jan 2008 15:53:46 GMT by Denim Umeshkumar Anajwala
Dear George,

it is of course possible to run FEFLOW interactively using an IFM module. However, for a start it might be easier to use PEST or FE-LM2, depending on your needs. The latter is directly integrated into FEFLOW and accessible via the tools menu entry (Start parameter fitting ...). A lot of additional details are given in the FEFLOW documentation. PEST has to be loaded as an IFM module.

Kind regards,

You must be signed in to post in this forum.