Please wait...
×

Error

Posted Fri, 09 Jul 2010 10:27:02 GMT by faby
Hi,
We are using FEFLOW 5.2, I want put add-in points on the boundary. But when i use F2 to assign the addin points, It does not accept the points Why?
When I used F2 in "continue point design it accepts.
But then in fine meshing these addinpoints on the boundary are not taken.
why?
Posted Fri, 09 Jul 2010 10:59:41 GMT by Denim Umeshkumar Anajwala
Directly on the boundary, I'd rather use nodes in the boundary polygon than add-ins.
Posted Wed, 14 Jul 2010 05:38:38 GMT by faby
o.k , but it does not take all the nodes, foer e.g. i put nodes at every50m interval but it took only the nodes at 100m while meshing, why??
Posted Thu, 15 Jul 2010 13:42:40 GMT by Denim Umeshkumar Anajwala
We have to distinguish between the nodes you have put, and intermediate nodes that are put automatically by FEFLOW. The latter ones are shown a bit smaller in editing mode, and are only used for creating curved lines. Thus only the large nodes are used for the mesh generation.

You must be signed in to post in this forum.