Please wait...
×

Error

Posted Thu, 02 Jan 2014 19:09:20 GMT by Steven Humphrey
Just installed 6.2 and I'm not seeing the in-/active elements parameter in the Data panel.
Posted Fri, 03 Jan 2014 08:41:31 GMT by Carlos Andres Rivera Villarreyes Global Product Specialist - FEFLOW
In the new FEFLOW 6.2, 3D models with an unconfined layer (Free and Movable approach) cannot support deactivation of finite elements. Since the Free-Movable approach makes a down-scaling of conductivity based on the movable slice position (avoid non-fully-saturated elements), it is not possible to offer deactivation of elements here at the moment.
Posted Wed, 22 Jul 2015 13:55:34 GMT by Alice Donna
Hello

I am using Feflow 6.1 but I don't see this in-/activate elements option in the data panel. Is it normal or should I see it? Where?

Thank you
Posted Wed, 22 Jul 2015 16:55:43 GMT by Björn Kaiser
The deactivation and reactivation of elements is a development of FEFLOW 6.2. FEFLOW 6.1 and earlier versions do support inactive elements.

You must be signed in to post in this forum.