Hello all
After a five-year absence, I'm back using FEFLOW. Not only that, I'm attempting to use FePEST.
On my very first attempt, I've run into a problem that I can't figure out.
It's a simple model. I'm trying to estimate six parameters of a 2D, vertical slice, steady-state model. Six Kmax zones and six anisotropy ratios. I've gone through the setup and the checks and everything seems OK but when I run the model, I get the following error messages:
[font=courier]******************************************************************************
Error condition prevents continued PEST execution:-
Cannot open model output file n1_0032p.fpo.
******************************************************************************
[ERROR] File not readable: '[path]\FEM\femdata\N1_0032P\n1_0032p.fpi'
[/font]
When I look in the model folder, I see that the .fpo file does not exist, however, the .fpi file does exist and has the following contents:
[font=courier]con-1 2.8000000E-01
con-2 2.3685000E-02
con-3 1.2478100E-03
con-4 1.0000000E-04
con-5 3.0175000E-03
con-6 4.7128700E-03
fac-1 1.0000000E+00
fac-2 1.0000000E+00
fac-3 5.0000000E-02
fac-4 1.0000000E-01
fac-5 2.0000000E-01
fac-6 3.0000000E-01[/font]
Any suggestions?
