Please wait...
×

Error

  • recharge problems

    Hi:feflow users

    I am modelling a saturated near-surface four-layer system (flow only).The top slice is set as “free &movable” (all other slices are “unspecified”except last silce fixed) .  The model gets recharge at the surface from rainfall, but surprisingly
    the water table is not expected to rise to the surface at certain locations.Even i change the "in flow on top"data to 190(e-4m/d),about 100mm rainfall daily,the water table still keep steady.All the parameters got through pumping test in the first layer are convincible.Then i check budget analyzer,the results show that recharge is about 24000m3/d.where is so massive flux? Rather confused!!

    Any suggestion is welcomed.

    yours:David