Anthony Barr

Apologies - As usual found the solution almost immediately after I posted the question.  The area was part of a selection in 3D window - once the selection was cleared the plot was in full colour.

Anthony

Hi all,

I've been plotting cross-sections from a 3D model and the colours are "washed out" compared to the legend and on the properties panel (User data .  The colours are correct in slice/3D views.  I have adjusted opacity to 100% form the default of 50%.  Does anyone have any suggestions as to how to get the full intensity of the colours?

I'm using FEFLOW v6.2(p6)

regards

Anthony

Hi all,

I have a large multi-layer version 6.2 model with fine discretisation in the mesh around proposed abstraction bores.  I would like to move the bores and "derefine" the mesh where the bores were previously located to speed up the model.  However when I select an area either in element or nodal modes, I cannot get the derefinement to work.
Does anyone have any suggestions as to how to derefine the mesh?
regards
Anthony