-
How to modify the recharge component with the 2-Layer UZ/ET
Hi,
I have a Mike SHE/Mike 11 model, which includes these modules: Snow melt, OL, SZ, 2-Layers UZ/ET. I'm trying to roughly calibrate my water-balance before fine tuning every parameters. I noticed that there is too much recharge and not enough overland flow to river. I'm wondering how to adjust these components because every input parameters (water content at saturation, water content at field capacity, PWP, ET surface) are based on literature values. Does any one know which of these parameter have the greater influence on infiltration/overland flow ? What would be the best procedure to reduce Infiltration and increase OL ?
Thank you !
You’re offline. This is a read only version of the page.
