Anne Hansen

Thank you Carlos and Pete for your answers, and to Peter for the video. I will have a look at it and see if I can get one of your suggestions to work. If not I will get back to you.

Regards,
Anne

Dear Peter,

Thank you for your answer. I just wanted to have an idea of how to apply evapotranspiration on a model setup. Is it just to apply a fluid-flux BC on the nodes in fx. the upper 1 m of the domain and then use the equation editor to define how the flux depends on fx. the model calculated saturation?

Best regards,
Ane

Hi,

I have seen some old posts where a link is given to a demo video on how to apply evapotranspiration in a Feflow model. But I cannot find the video using that link anymore.
Has the video been moved to a new location?

Best regards,

Anne