web
You’re offline. This is a read only version of the page.
close
Please wait...
×

Error

  • AUTOCAL Simulation Fails – “Number of failed simulations too high”

    Hello everyone,

    I'm currently working on a hydrological model in MIKE SHE, and I'm running into an issue during a sensitivity analysis with AUTOCAL.

    Each time I launch the simulation, I get the following error after a few parameter sets: 
    UTOCAL simulation: Sensitivity analysis

    Simulation option:  Sensitivity analysis
    Algorithm:          Local sensitivity analysis

    Evaluation of parameter set No. 1 initiated
    Evaluation of parameter set No. 2 initiated
    Evaluation of parameter set No. 3 initiated
    Evaluation of parameter set No. 4 initiated
    Evaluation of parameter set No. 5 initiated
    Evaluation of parameter set No. 6 initiated
    Evaluation of parameter set No. 7 initiated
    Evaluation of parameter set No. 8 initiated
    Evaluation of parameter set No. 3 completed: FAILED - model run error
    Evaluation of parameter set No. 9 initiated
    Evaluation of parameter set No. 4 completed: FAILED - model run error
     
    Error: Unable to continue. No of failed simulations too high.
     

    Has anyone experienced this before?
    Thanks in advance for your help!