Alberto Roman Gessa Fernandez

Hello Jeremy,

I am getting the same, or a similar (8 years have past) error, did you get any solution to this problem?

Thank you and regards,
Roman

Hello all,

After building a model, I want, and I tried, to calibrate it with FePEST tool with the PEST ++ Package. I got the same problem changing the Operation mode and with/without Parallelization.

The actual problem is that after I while I get this error from the log:

"Thread processing instruction file 'v010_calibration.ins' raised an exception: instructionfile error in file 'v010_calibration.ins' : output file'v010_calibration.fpo' not found, aborting model run"

And after checking I see that no fpo has been created by FePEST. Any similar experience? Any advice? I will be glad to give more information if required to contextualise.

Thank you in advance and regards,
Roman

Hello,

I was following the course "FEFLOW-Advance modelling of complex geologies" and got and issue I wondered if you could help me with.

After adding the files .ts , I proceed to convert them to 3D supermesh element, but when I do right click on them that option doesn't appear (please, see attached picture). What can be the reason for that?

Thank you in advance,
Roman