Please wait...
×

Error

  • Mike11, Feflow and ifmM11 conection

    Hello,

    I have a question regarding the setup of a coupled models MIKE11 and FeFlow with ifmM11.

    I will model an unconfined alluvial aquifer which is in strong connection with the river (around 50% recharge and even more discharge). Riverbed has lower conductivity (transfer rate, conductance) than the aquifer.

    I have already a very good model for the river in MIKE11 and will use it in FeFlow model. My question is:

    how to create a 3D model of an aquifer and a river with lower riverbed conductivity in FeFlow which is going to be coupled with MIKE11.

    1. do I need a separate layer of the river because of different conductivity? I presume yes, otherwise if I have only one layer and if I use Fluid-Transfer BC and a different transfer rate then I will get vertical barrier through the whole aquifer (model), right? How could I set up the second layer only around the river (some kind of buffer?)
    2. I should use Fluid-transfer BC and  [b]In-transfer rate and Out-transfer rate (both?)[/b] where I put transfer rate for the riverbed?
    3. when coupling MIKE11 and FeFLOW is there anything special I should pay attention to? Or I could just use normal coupling without special boundary conditions?

    Thanks for your help,
    Best regards,
    Dejan