Medria_85

Hi everyone,

I would like to know how I can properly set up the parameters of standard boundaries in MIKE Hydro. The source of water from all upstream chainage in the model is from rainfall. However, when I run the simulation, there is always an error message: "0 is defined as an open boundary in the model, however no open boundary is defined (EN_ERR_OpenBndMissing).

I have defined the parameters as follow:
Type: Rainfall
Location type: Distributed source
Input type: Time varying (with rainfall data- dfs0 file)

I wonder if there is another parameter that I have missed? I would like to know how to solve the problem.

Thank you very much
Cheers

Medria