-
Re: I cannot email "support@dhi-wasy.de"
Thank ou Carlos for your answer. However, this is the adress to contact for existing plug-ins (see link below).
Best regards.
http://www.feflow.com/existing_ifm_modules.html?&no_cache=1 -
I cannot email "support@dhi-wasy.de"
Dear Webmaster,
Is there a problem with internet adress "support@dhi-wasy.de" ? I cannot send email anymore on this adress : "support@dhi-wasy.de".
Here is the undeliverable message : "The e-mail address you entered couldn't be found. Please check the recipient's e-mail address and try to resend the message. If the problem continues, please contact your helpdesk." -
Set the extraction concentration at the injection nodes of an open loop system
Hi everyone,
Here is a simple question : is there a way to set the extraction concentration at the injection nodes of an open loop geothermal system within a time-varying boundary condition ?
Thank you all for your help.
Morgan -
Numerical model versus Finite Line Source (FLS) for Borehole Heat Exchanger (BHE
[size=10pt][size=8pt]Hi everyone,
I am trying to reproduce finite line source solution (FLS) for a 100m deep borehole heat exchanger (BHE) with a reservoir homogenous initial temperature of 10°C folowing Diersch advice on numerical modelling. So far, I did not manage to obtain a good agreement between numerical model and analytical solution. I wanted to know if someone already tried this comparison or if someone has further information on that subject.
Thanks for your help.
Morgan[/size][/size]