Runtime Error Message

My Integrated MIKE 21 HD/SW terminated prematurely with the following message in the run log file:

"Cannot flush files".

There were 4 sets of parallel runs and the CPU was fully used. The harddisk was adequate for the output files. However, I did have a 5th shorter run started and the above crash occurred while this shorter run was ongoing, and this shorter run did complete successively after the above crash.

What could cause this problem and how could I fix it?

Thanks and regards,

Say Chong

You may have run out of RAM memory. Try running the simulations again but sequentially.
I would advise you against running several simulations at the same time as that could cause problems.

Best regards,
Ricardo Machado

Hello friends and I all new member named Kevin.