You’re offline. This is a read only version of the page.
Please wait...
×
Error
X
Toggle navigation
Download Center
Download Center
MIKE 2024 Update 1
Scientific Publications
Knowledge Base
MIKE Forums
Contact Support
Contact Sales
Contact Sales
Service and Maintenance Agreements
All
All
Forums
Knowledge Articles
Search Filter
All
Forums
Knowledge Articles
Search all support and community content
Sign in
DHI Group
MIKE Powered by DHI
DHI Training Portal
Metocean Data Portal
Bathymetrics Data Portal
MIKE Cloud Admin
Home
MIKE Forums
FEFLOW
one layer coastal aquifere model
one layer coastal aquifere model
Posted
Thu, 18 Mar 2021 12:47:57 GMT
by
Nyidier Maloun
i have no company
Hello everyone;
i have a one layer coastal aquifere model,
when i assign all the boundary conditions plus the material properties and i simulate in gives me hydraulic heads on slice 2 (bottom slice)
and for slice 1 (top slice) it gives me hydraulic head =0 as shown on the photos attached;
i can't figure out what could be the problem !!
any help???!!!!!!
Capture1111.PNG (216.6 KB)
Capture1111.PNG_thumb (25.1 KB)
Capture.PNG (198.9 KB)
Capture.PNG_thumb (24.9 KB)
Posted
Fri, 19 Mar 2021 07:11:46 GMT
by
Peter Schätzl
Grundwassermodellierer
Also on your bottom slice hydraulic head is zero nearly everywhere - only in a few nodes it is higher. You should definitely check your boundary conditions in this model.
Posted
Fri, 19 Mar 2021 18:59:26 GMT
by
Nyidier Maloun
i have no company
thank you Peter Schätzl for replying me
does the well's radius affect the results because i don't have the radius data??
You must be signed in to post in this forum.