Please wait...
×

Error

Posted Thu, 02 Jun 2011 03:40:35 GMT by lemonok
hello,
in FeFLOW BHE is represent by a single point(P) see from  the surface , but I want to know should we design the mesh around  point P in such a way that the the distance from the around mesh points to point P meets the physical radius of borehole wall which we defined in BHE setting menu?
Thanks for your help
Posted Fri, 03 Jun 2011 11:13:13 GMT by Denim Umeshkumar Anajwala
I recommend to go through the White Papers, Vol. V, chapter 1.11 (http://feflow.info/uploads/media/white_papers_vol5_02.pdf). This contains a detailed discussion of the influence of discretization around the BHE on the results.

You must be signed in to post in this forum.