Please wait...
×

Error

Posted Fri, 20 May 2011 06:55:23 GMT by Terry CORDONNIER engineer
Hi,

I have to measure a surface on the 3D-view to put values for a "Fluid-flux BC".
Related to my last topic, i have values for fluid flux BC in [b]m3/s[/b] and the software accept only [b]m/s[/b] data !!!

Regards,

Terry
Posted Fri, 20 May 2011 07:58:50 GMT by dvb
What I usually do is using a GIS to estimate the surface, and then I can calculate the appropriate flux (F=Q/S). With budget you can control that you are ending with the correct flow rate. If necessary you can adjust.

I have not seen yet a measurement tool for either area or lenght in V6. That would be very nice to have (at least on 2d views).

Cheers !
Didier
Posted Fri, 20 May 2011 11:03:27 GMT by Joseph Clarkson
Hi, I'm not sure if I understand the problem, but you can try to read my recent post concern the measurement problem... http://www.feflow.info/forum/index.php/topic,1015.0.html
Posted Mon, 23 May 2011 04:52:57 GMT by Terry CORDONNIER engineer
Thank you all !!
I will approximate the surface with a GIS tool... :)

You must be signed in to post in this forum.