Multi-well boundary constraints

Hi All,

I have a series of multi-wells in a 35 layer model and I need to assign well constraints to these boreholes.

Do I need to assign to every layer where the multi-well is present or only at the bottom?

Thanks in advance

At the bottom is sufficient. But be careful: Using hmin on the well might lead to infiltration at the well node if the water level drops below hmin.

Hi,
I have a point shapefile in order to import the wells, i use assign/database/2D Akima interpolation/import the shp/Apply/wells/automatic regionalization with snap distance, is that right? Some of the wells aren't on a node and when i check on them with mesh inspector, shows that no conditions are set, what can i do?
Thanks!
Irene