Please wait...
×

Error

Posted Sat, 13 Jun 2015 07:31:45 GMT by samsamia22
Hello everyone,

I have a 3D model with inactive elements representing an excavation. I was wondering if it was possible to make these elements invisible rather than change their color (for localisation purposes only) so I can see the different layers that were excavated.

Thank you
Posted Mon, 15 Jun 2015 07:12:52 GMT by Björn Kaiser
If the color of the inactive elements and the color of the background are the same, inactive elements get invisible. In the View Components panel, double-click on [i]In-/active Elements[/i] to open the corresponding properties. Switch the color from red to the color you use also use for the background.
Posted Tue, 16 Jun 2015 15:58:02 GMT by psinton@aquageo.us
another possibility is to use an element selection that excludes the elements that you want to be invisible. When you activate such a selection, and then add to any view the element data you want to see, only the elements of the selection will be shown.

You must be signed in to post in this forum.