web
You’re offline. This is a read only version of the page.
close
Please wait...
×

Error



Posted 16 years ago by Denim Umeshkumar Anajwala
I have been told that it may be possible to run two Feflow models simultaneously, where the boundary conditions in one model are determined by the output/boundary condtions of another model. Is there a way of doing this? It is most likely that I will want to use the flux out of one model to detemine the flux entering the other. How might I go about this?

Thanks,

SB
Posted 16 years ago by Denim Umeshkumar Anajwala
No longer taking this approach, so answer not actually needed (but still interesting!).

You must be signed in to post in this forum.