You’re offline. This is a read only version of the page.
X
Toggle navigation
Knowledge Base
MIKE Forums
Contact Support
Contact Sales
All
All
Forums
Knowledge Articles
Search Filter
All
Forums
Knowledge Articles
Search all support and community content
Sign in
DHI Group
MIKE Powered by DHI
DHI Training Portal
Home
MIKE Forums
FePEST
parameter zone
parameter zone
Posted
Thu, 31 May 2018 12:27:25 GMT
by
Bill Langley
Research Associate Professor
After creating and saving a parameter zone in my Feflow file, the parameter zone does not appear when this file is opened in Fepest. I'm attempting to follow the steps from the tutorial in Fepest user guide. Thanks
Posted
Mon, 04 Jun 2018 10:51:26 GMT
by
Björn Kaiser
After you edited and saved the fem-file you need to refresh by clicking on Edit and then on Reload FEM file...
Posted
Mon, 04 Jun 2018 10:59:22 GMT
by
Bill Langley
Research Associate Professor
OK, thanks. Also, saved the zone as an element selection in the selections panel, instead of the entities panel.
You must be signed in to post in this forum.
