Ridwan

I finally succeed generating the appropriate mesh for my modelling, after countless revision (starting over from scrap repeatedly).
I also succeed simulating the FMHD module (shore hydrodinamic only, i.e: current), but I'm having trouble again in simulating the SW module, it's done to resulting designated point data (.dfs0) and area (.dfsu). Problem is, why does the maximum wave heights resulted are so very low while the significant waves that had been assigned from basic calculation are reasonably acceptable. Would anyone care to help me overcome this?

Thank you..

Thank you for responding my difficulties,

I finally succeed generating the appropriate mesh for my modelling, after countless revision (starting over from scrap repeatedly).
I also succeed simulating the FMHD module (shore hydrodinamic only, i.e: current), but I'm having trouble again in simulating the SW module, it's done to resulting designated point data (.dfs0) and area (.dfsu). Problem is, why does the maximum wave heights resulted are so very low while the significant waves that had been assigned from basic calculation are reasonably acceptable. Would you help me to overcome this?

Thank you..

Hello,

I'm having difficulties in generating mesh in mike zero mesh generator. The area has been set according to the guidance of UK MIKE 21 Guide - Marine.pdf and Mesh_Generator_step_by_step.pdf.
The area is set (the boundaries are well defined).

Question is, why does the triangulation doesn't start processing when i click the triangulate button? it doesn't even shows suggestion or even error messages..... contradictive with the manuals and the previous experiences when i succeeded to generate mesh and modelling results for another locations.

Would be very grateful for solutions.
Thank you