Posted Sat, 14 May 2016 14:37:40 GMT by Karanka

I tried to insert 7 [b]multilayer wells[/b] into a model characterized by 4 layers in order to run a transient simulation and evaluate the pathlines: when I open the .dac file resulting from the simulation the pathlines/streamlines are not visible or there aren't; if I use a [b]well BC[/b] the pathlines/streamlines are visible in the .dac file!!

I wuold specified that performing the model with both the approaches the budget analysis (consequently the pumping rate) is correct.

what could be the cause of this problem? Why the pathlines are not visible using a multilayer wells approach?

Thank you in advance

Posted Mon, 30 May 2016 11:05:14 GMT by Björn Kaiser
Did you impose a reasonable radius for the field lines?

You must be signed in to post in this forum.